If there were metal shavings I would not hesitate to replace the crank bearings.. but that is just me.
If there were metal shavings I would not hesitate to replace the crank bearings.. but that is just me.
Did you have to pay anything?
Got the bottom end all done and together. Just need to throw the head on and set the timing and get her some new oil and put her in the bike.
Takes so damn long :/ trying to make sure everything is clean while putting her together!!!
Should of done crank bearings.....oh well.
THANK JAYSUS
when i got the pressed in, they dude said they looked fine but just in case...
So i got the timing set, it started right up.
however when the bike shuts off i hear a click sound like the auto decompression lever hitting. is this normal for honda bikes with auto decompression?!?!?
also everytime i put it in gear it stalls, so i think i need to adjust the clutch and put some tranny oil in her, as i used engine oil just to flush it out right after the rebuild. anything else i should look at for this stalling issue?
i will upload pictures in a few when i get up loaded