Good evening all,
I recently bought a 07 RM 250 and gave been trying to do a light over haul on the bike. I'm stuck on thge carb however. I bought a rebuild kit and cleaned up everything. However I think my jet block is warped.. it isn't allowing the needle and slide to move smoothly. Idk if the block warped after i pulled the bolts out to clean everything up. The slide and needle move freely until I tighten the screws down.
Then it gets stuck. I am trying to find a shop manual that has part # in case u need to order a new block.
I recently bought a 07 RM 250 and gave been trying to do a light over haul on the bike. I'm stuck on thge carb however. I bought a rebuild kit and cleaned up everything. However I think my jet block is warped.. it isn't allowing the needle and slide to move smoothly. Idk if the block warped after i pulled the bolts out to clean everything up. The slide and needle move freely until I tighten the screws down.
Then it gets stuck. I am trying to find a shop manual that has part # in case u need to order a new block.