250F Hesitation off idle

hondacr500af · May 17, 2014

Mihylo33:
He doesn't need race fuel right now and I'm sure he can't warrant the $13 a gallon. The av fuel is just for him to try an see if a higher quality controlled fuel suits his bikes needs.

I understand what you are saying. Can you tell me. What is the highest octane rating available at your local gas stations? Do they sell 100 octane unleaded? It should be a separate pump. If they do that may even be cheaper than the Aviation fuel. Possible even better results. :noidea:

josmoloco · May 17, 2014

91 octane here

josmoloco · May 17, 2014

Maybe its 92

hondacr500af · May 17, 2014

I am surprised. I buy 100 octane at our local Sunoco station. When I run out of the VP. Ultima 4.4. Normally the 100 octane varies in price. From 8 to 9.50 a gallon. Depending on season.

Mihylo33 · May 17, 2014

hondacr500af:
I understand what you are saying. Can you tell me. What is the highest octane rating available at your local gas stations? Do they sell 100 octane unleaded? It should be a separate pump. If they do that may even be cheaper than the Aviation fuel. Possible even better results.

None here. I need to go to east Brunswick for 104 Sunoco pump and even then it's $10 a gallon. Av fuel will only cost him about $5 a gallon

Edit: found a chart updated today for average prices.
Jet A100LL

NC $5.54 $6.10

NE $5.74 $6.31

NW $5.65 $6.39

SC $5.39 $5.89

SE $5.75 $6.19

SW $5.72 $6.34

josmoloco · May 17, 2014

I will try it if it's still an issue after I change and set fuel screw and install quick shot 3

josmoloco · May 17, 2014

Haven't really messed with it this week, just reassembled it. Busy with work

josmoloco · May 18, 2014

Looks like the ap diaphragm was in upsidedown. Can't have been helping

snowflake · May 18, 2014

:Gibbs:

hondacr500af · May 18, 2014

I can not believe you have not thrown in the towel yet. I give you credit for that. How far is your local bike shop from you. It sounds to me like you already did the hard part for them. So see what it would cost to have them finish it.

josmoloco · May 18, 2014

hondacr500af:
I can not believe you have not thrown in the towel yet. I give you credit for that. How far is your local bike shop from you. It sounds to me like you already did the hard part for them. So see what it would cost to have them finish it.

I havent actually been working on it. I was waiting for the qs3. Ask I have done prior was clean the carb std re jet