cleaned every part of the bottom end of my engine, installed my new main bearings, dismantled my power valve out my top end and cleaned all those parts too.
What did you do to your bike today?
- Thread starter jackson409
- Start date
Cleaned out the garage, moved the bieks from the shed to the garage and the shizzle in the garage to the trash, ? or shed...depending on what it was...tried starting ED... it started right up but wouldn't idle even with the choke on...then I remembered it's oudda gaz.....
...but hey, it started! 
...but hey, it started! 
Got my crank back from the shop, installed it and put the cases back together. Installed the seals, counter sprocket, stator and flywheel.
stop talkin about youir crank already....
lol Hey Jax, make sure you can turn the crank assembly and tranny assembly by hand. it needs to be easy and smooth turning..., just sayin.
Hey Jax, make sure you can turn the crank assembly and tranny assembly by hand. it needs to be easy and smooth turning..., Just saying.. In case you didnt know..
Damn, its already locked up...can't turn it by hand 
Nah, I did Mih oh and BK thanks I don't know what I would have done without your input 
.... it's good and smooth, I went through all the gears as best I could to make sure the tranny is right since the gears and washers only fell out 1000 times during the cleaning and when installing the bearings.
Nah, I did Mih
oh and BK thanks I don't know what I would have done without your input .... it's good and smooth, I went through all the gears as best I could to make sure the tranny is right since the gears and washers only fell out 1000 times during the cleaning and when installing the bearings.I removed all of the cylinder head studs. Getting ready to ship the cylinder off.
Cleaned out all of the bearing bores, made sure they were all smooth, replaced all but 1 transmission bearing(waiting on it) and I didnt get a chance to do my crank bearings, turns out the torch was outta gas 
