Forums
New posts
Search forums
Members
Current visitors
New profile posts
Search profile posts
What's new
New posts
New profile posts
Latest activity
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Everything Dirt Bike
General Dirt Bike
Clutch Problem
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="divemaster5734" data-source="post: 163368" data-attributes="member: 1320"><p>That's what I thought too, so even though I filed off the wear ridges on the basket, I bought one in excellent condition and swapped.</p><p></p><p></p><p></p><p></p><p></p><p>Yes. Once I get the inner hub plate off,( the one that holds in the clutch plates), the inner hub turns freely.</p><p>I have to use the clutch tool vice grips to remove the hex nut.</p><p></p><p></p><p></p><p>Even watching the inner hub end plate flex when I pull in the lever the clutch will not function.</p><p>I just assumed it was because the side cover was off, no oil, not spinning fast enough, etc..</p><p></p><p></p><p></p><p>hell of an idea.</p><p>I did look for any obvious signs of wear.</p><p>There's the water pump activator that holds the cover out a little, but that's at the fron end of the engine.</p><p>I'll take it apart again in the morning and try to discern any lever pull differences with side cover off or on.</p><p></p><p></p><p>All that being said, the cover fits tight enough to not leak oil, not sure if there's enough flex in the cast cover to bend that much without a crack.</p><p></p><p></p><p></p><p>Thanks to all that responded.</p></blockquote><p></p>
[QUOTE="divemaster5734, post: 163368, member: 1320"] That's what I thought too, so even though I filed off the wear ridges on the basket, I bought one in excellent condition and swapped. Yes. Once I get the inner hub plate off,( the one that holds in the clutch plates), the inner hub turns freely. I have to use the clutch tool vice grips to remove the hex nut. Even watching the inner hub end plate flex when I pull in the lever the clutch will not function. I just assumed it was because the side cover was off, no oil, not spinning fast enough, etc.. hell of an idea. I did look for any obvious signs of wear. There's the water pump activator that holds the cover out a little, but that's at the fron end of the engine. I'll take it apart again in the morning and try to discern any lever pull differences with side cover off or on. All that being said, the cover fits tight enough to not leak oil, not sure if there's enough flex in the cast cover to bend that much without a crack. Thanks to all that responded. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Everything Dirt Bike
General Dirt Bike
Clutch Problem
Top