1st
Drain the oil then take the clutch cover off, its usually 8mm bolts
2nd
Undo the bolts on the pressure plate and springs the same way you did the cover
3rd
Take the old plates out, you need 2 flat head screw drivers for this, use them to pry all of the old plates out, it does not matter if you break them or hurt them. there getting replaced.
4th
Soak the fiber plates in oil for about 30 minutes
5th
Install the friction plates and steel plates, starting with a friction plate and alternating them. Finishing with a friction plate. There are painted marks on the tangs of the first and last friction plates.
6th
Put the springs in the pressure plate then snug down the bolts, they dont need to be too horribly tight about 15 pounds
7th
Re fill it with new oil
8th
Adjust the clutch then
Drain the oil then take the clutch cover off, its usually 8mm bolts
2nd
Undo the bolts on the pressure plate and springs the same way you did the cover
3rd
Take the old plates out, you need 2 flat head screw drivers for this, use them to pry all of the old plates out, it does not matter if you break them or hurt them. there getting replaced.
4th
Soak the fiber plates in oil for about 30 minutes
5th
Install the friction plates and steel plates, starting with a friction plate and alternating them. Finishing with a friction plate. There are painted marks on the tangs of the first and last friction plates.
6th
Put the springs in the pressure plate then snug down the bolts, they dont need to be too horribly tight about 15 pounds
7th
Re fill it with new oil
8th
Adjust the clutch then