Forums
New posts
Search forums
Members
Current visitors
New profile posts
Search profile posts
What's new
New posts
New profile posts
Latest activity
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Everything Dirt Bike
General Dirt Bike
Anyone got a PW80 workshop manual on PDF
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="ossagp" data-source="post: 197989" data-attributes="member: 1650"><p>stator is 43 on the rotor. clutch center nut shows 35-37. my friend gene has these notes and has had three of these that his grandkids rode. there is still one at his place. they built one up to play race and they used a big bore piston that they came up with and made some piston pin adaptors to do so. it flew but was kind of impraticle, i mention it because his note shows that stock for the head nut is 7-8 (all these in foot pounds). he noted that they went up on torque a bit at a time and found the cases wouldnt hold the torque needed (18 plus) and that the stock settings wouldnt always hold pressure. They used a helicoil copy on the cases and it held fine. fyi if you are thinking along any of those lines.</p></blockquote><p></p>
[QUOTE="ossagp, post: 197989, member: 1650"] stator is 43 on the rotor. clutch center nut shows 35-37. my friend gene has these notes and has had three of these that his grandkids rode. there is still one at his place. they built one up to play race and they used a big bore piston that they came up with and made some piston pin adaptors to do so. it flew but was kind of impraticle, i mention it because his note shows that stock for the head nut is 7-8 (all these in foot pounds). he noted that they went up on torque a bit at a time and found the cases wouldnt hold the torque needed (18 plus) and that the stock settings wouldnt always hold pressure. They used a helicoil copy on the cases and it held fine. fyi if you are thinking along any of those lines. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Everything Dirt Bike
General Dirt Bike
Anyone got a PW80 workshop manual on PDF
Top