1967 Suzuki AS100 Enduro Bike Build

MrMan

MrMan

SRAD97750:
Is there a bolt that still threads in?
That doesn't look salvagable, unless it still functions as intended, then just run it.
-BIG DAN:thumb:
Click to expand...
Nope, no bolt. Perhaps with some very careful hammering, I can get it so a condition where I’ll be able to get a bolt on it. Or, do I just cut that bit off with a hacksaw or something?

btw, Thanks for all the Help Dan!!
 
SRAD97750

SRAD97750

Moderator
Staff member
MrMan:
Nope, no bolt. Perhaps with some very careful hammering, I can get it so a condition where I’ll be able to get a bolt on it. Or, do I just cut that bit off with a hacksaw or something?

btw, Thanks for all the Help Dan!!
Click to expand...
Looks like it was originally a nut on the end of that shaft. You'll have to find a way to retain the flywheel on the shaft, or get a new crank.
-BIG DAN:thumb:
 
MrMan

MrMan

SRAD97750:
Looks like it's had a hard life. Maybe fella didnt know it was LH threads, or was prying in there.
-BIG DAN:thumb:
Click to expand...
Yup, I hope I can get it going again…. So I guess my only hope now is to rethread the holes in the flywheel… (not the main one, there are others)
 
MrMan

MrMan

Ok, I can’t get the flywheel off (I’ve used all the different types of pullers) So now I’m considering an engine swap, I’d like to keep it below $200 for the engine + ignition stuff. Anyone have suggestions? (A used engine is fine with me)
 
Top