Grips and hand guard question

so i just got some cyra hand guards and new progrip grips as i was installing i noticed i needed a hole in the end of the grips so i didng cut the side off i just pierced a hole with a screw driver and screwed it in but havent done the accelerator side is it a must to cut the end off with hand guards or am i good with just a pierced hole???thanks :)
 

SRAD97750

Moderator
Staff member
so i just got some cyra hand guards and new progrip grips as i was installing i noticed i needed a hole in the end of the grips so i didng cut the side off i just pierced a hole with a screw driver and screwed it in but havent done the accelerator side is it a must to cut the end off with hand guards or am i good with just a pierced hole???thanks :)
You will have an issue with the throttle side, as it needs to turn freely.
Just use a box opener and run around the bar with it, and cut off the end bit. -BIG DAN:thumb:
 
Top