Forums
New posts
Search forums
Members
Current visitors
New profile posts
Search profile posts
What's new
New posts
New profile posts
Latest activity
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Everything Dirt Bike
Make / Model Specific
Honda
four stroke wont start top end rebuild
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Beachum" data-source="post: 180332" data-attributes="member: 2521"><p>1984 Honda xl200r. Installed new cylinder, piston and rings. New fuel lines and carb. New ignition coil/spark plug wire. Valves adjusted correctly and installation sequence followed by clymer manual for third time now. Wont start, it was trying to advanced and kicking back. Now only backfres once in a while. I've noticed on the compression stroke at TDC (when the spark should spark) the pulse rotor is 180 degrees away from the pulse generator. This is why I have been back into the top to see if I messed up the sequence of installation but it all checks out as far as I can see (if that is a problem maybe thats normal the marks between rotor and generator not lining up at time of spark...im not sure and manual says thats correct since you cant put the rotor on wrong with the locating dowel and all) I need help....</p></blockquote><p></p>
[QUOTE="Beachum, post: 180332, member: 2521"] 1984 Honda xl200r. Installed new cylinder, piston and rings. New fuel lines and carb. New ignition coil/spark plug wire. Valves adjusted correctly and installation sequence followed by clymer manual for third time now. Wont start, it was trying to advanced and kicking back. Now only backfres once in a while. I've noticed on the compression stroke at TDC (when the spark should spark) the pulse rotor is 180 degrees away from the pulse generator. This is why I have been back into the top to see if I messed up the sequence of installation but it all checks out as far as I can see (if that is a problem maybe thats normal the marks between rotor and generator not lining up at time of spark...im not sure and manual says thats correct since you cant put the rotor on wrong with the locating dowel and all) I need help.... [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Everything Dirt Bike
Make / Model Specific
Honda
four stroke wont start top end rebuild
Top