Forums
New posts
Search forums
Members
Current visitors
New profile posts
Search profile posts
What's new
New posts
New profile posts
Latest activity
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Everything Dirt Bike
Make / Model Specific
KTM
96 250 sx won't hit power valve
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="96sx" data-source="post: 207633" data-attributes="member: 4024"><p>no it wasn't working on my last trip out and my compression was 120psi. So I rebuilt top end including my power valve and replaced my reeds. Is there a gasket that goes between my intake tube and power reeds? When I got my reeds from boysen they came with a rev plate I used it and it wouldnt start. So I put on my stock reed stops it fired right up. Also in the diagram in manual shows a gasket that goes between each reed. That wasn't included or in my old set? My z dimension was set at 48mm not sure if that is correct. It says 99' and older models. Power valve has hit after rebuild just randomly though. And I know everything is to spec and put together right. An air leak would make it hit randomly? Thanks for the feedback.</p></blockquote><p></p>
[QUOTE="96sx, post: 207633, member: 4024"] no it wasn't working on my last trip out and my compression was 120psi. So I rebuilt top end including my power valve and replaced my reeds. Is there a gasket that goes between my intake tube and power reeds? When I got my reeds from boysen they came with a rev plate I used it and it wouldnt start. So I put on my stock reed stops it fired right up. Also in the diagram in manual shows a gasket that goes between each reed. That wasn't included or in my old set? My z dimension was set at 48mm not sure if that is correct. It says 99' and older models. Power valve has hit after rebuild just randomly though. And I know everything is to spec and put together right. An air leak would make it hit randomly? Thanks for the feedback. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Everything Dirt Bike
Make / Model Specific
KTM
96 250 sx won't hit power valve
Top