Forums
New posts
Search forums
Members
Current visitors
New profile posts
Search profile posts
What's new
New posts
New profile posts
Latest activity
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Everything Dirt Bike
Make / Model Specific
Suzuki
94rm80 bogs/stalls 4th 5th gear
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="ossagp" data-source="post: 209659" data-attributes="member: 1650"><p>pull the spring up towards that scerw down cap and get some of the cable exposed. with the spring up out of the slide you can see if there are screws holding the casting that the cable goes into. if so you may remove those, or see if you can get the cable out by pushing down out of the blind socket, and then flick the cable out through that slot. </p><p></p><p>as for the float setting you can priobably get really close by looking at the floats from the side and lifting them with your finger to where that brass tang that contacts the needle is just contacting it without compressing the spring. on that model the float mold lines should be level with the gasket surface of the carburetor body. you can bend that tang up or down to make that happen. while you are in there remove the float needle and make sure there is no dirt etc . once done you can blow through the fuel line with the float in the open or down position and move it to shutoff and see if you are getting a decent seal.</p><p></p><p>now what does the spark plug look like?</p></blockquote><p></p>
[QUOTE="ossagp, post: 209659, member: 1650"] pull the spring up towards that scerw down cap and get some of the cable exposed. with the spring up out of the slide you can see if there are screws holding the casting that the cable goes into. if so you may remove those, or see if you can get the cable out by pushing down out of the blind socket, and then flick the cable out through that slot. as for the float setting you can priobably get really close by looking at the floats from the side and lifting them with your finger to where that brass tang that contacts the needle is just contacting it without compressing the spring. on that model the float mold lines should be level with the gasket surface of the carburetor body. you can bend that tang up or down to make that happen. while you are in there remove the float needle and make sure there is no dirt etc . once done you can blow through the fuel line with the float in the open or down position and move it to shutoff and see if you are getting a decent seal. now what does the spark plug look like? [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Everything Dirt Bike
Make / Model Specific
Suzuki
94rm80 bogs/stalls 4th 5th gear
Top