Forums
New posts
Search forums
Members
Current visitors
New profile posts
Search profile posts
What's new
New posts
New profile posts
Latest activity
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Everything Dirt Bike
Make / Model Specific
Honda
1988 CR250R Wont start / Wet Plug
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Stringer" data-source="post: 177227" data-attributes="member: 2086"><p>Finally after a week in USPS custody, I have received my used eBay cylinder and head today (and powervalve assemblies, covers, tons of hardware, gaskets, etc)! Obviously I'm no expert, but this looks to be in good condition. I hit them up with some engine degreaser, then on to a bucket of hot water, soft plastic brush, and dawn soap. A real good rinse, then wiped dry and wd40 applied to steel parts and wiped again.</p><p>[ATTACH=full]23410[/ATTACH]</p><p>[ATTACH=full]23411[/ATTACH]</p><p>[ATTACH=full]23412[/ATTACH]</p><p>Immediately brought cylinder to brother in law's house and had it spec'd. We both measured, and came up with the same figure using his tools. He had a snap (something) set, and used some kind of caliper to guage the snap tools. The caliper was supposed to be of very high quality, it had a dial but read only in inches so I did the conversion. The reading we both got was 2.615" which converts to 66.421mm. So what piston set should I get? Right now I have no clue what size piston to order. I am so anxious to order so hopefully, that will be the last thing I need (fingers crossed!)</p></blockquote><p></p>
[QUOTE="Stringer, post: 177227, member: 2086"] Finally after a week in USPS custody, I have received my used eBay cylinder and head today (and powervalve assemblies, covers, tons of hardware, gaskets, etc)! Obviously I'm no expert, but this looks to be in good condition. I hit them up with some engine degreaser, then on to a bucket of hot water, soft plastic brush, and dawn soap. A real good rinse, then wiped dry and wd40 applied to steel parts and wiped again. [ATTACH=full]23410[/ATTACH] [ATTACH=full]23411[/ATTACH] [ATTACH=full]23412[/ATTACH] Immediately brought cylinder to brother in law's house and had it spec'd. We both measured, and came up with the same figure using his tools. He had a snap (something) set, and used some kind of caliper to guage the snap tools. The caliper was supposed to be of very high quality, it had a dial but read only in inches so I did the conversion. The reading we both got was 2.615" which converts to 66.421mm. So what piston set should I get? Right now I have no clue what size piston to order. I am so anxious to order so hopefully, that will be the last thing I need (fingers crossed!) [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Everything Dirt Bike
Make / Model Specific
Honda
1988 CR250R Wont start / Wet Plug
Top